(727) 808-8602
What a crank-scraper is and other technical info... Some comments on our products...
 
Alfa-Romeo,AMC,BMC,BMW,Buick,Buick-Rover,Cadillac,Chevrolet,Chrysler/Mopar,Datsun-Nissan,Fiat-Lancia,Ford,GM,Honda/Acura,IHC,Jaguar,Lotus,Mazda,Mercedes,MGA/MGB,Mitsubishi,Oldsmobile,Opel,Pontiac,Porsche,Renault,Studebaker,Suzuki-Geo,Toyota,Triumph,VW,Volvo
Home Latest New Products Customers' Rides Orders, Terms and Conditions

We will try to keep this list updated but if you do not see your engine listed here please ask!  We will try to keep this list updated but if you do not see your engine listed here please ask!  We can  do custom stroker or knife-edge crank designs.  We can provide templates for initial fitting and adjustment. Templates cost $100 and are a separate charge from the scraper pattern chosen.

 

We have included some representative pictures of the scrapers we make.  If you would like to see a picture of a particular scraper please ask -- we would be more than happy to send one through.

 

When available (please enquire) our zero-clearance Teflon® scrapers run an additional $130.00 to the cost of the standard steel scraper unless noted.

 

Remember, your vehicle may have an engine made by a different manufacturer so check both product lines.  If you are still unsure, please contact us.

 

crankscraper, crank-scraper, crank-scrapper, crank, crankshaft, rod-bearing, main-bearing, connecting-rod, counterweight, piston, windage, windage-tray, windage-cloud, oil pan, oil-pan, oil-aeration, oil-foaming, oil-cloud, racing, drag racing, road racing, drag-race, road-race, road-course, drift, drifting, time-trial, performance, power, horsepower, HP, torque, TQ, friction, vacuum, economy, engine, motor

 

Chevrolet

 

 

 Copyright 2002-2024 © All rights are reserved on our product designs.

June 2021 feedback: A customer reordering a steel 2.8 scraper shared that he found that the scraper reduced his ET in the 1/4 mile by a tenth of a second.  The engine was turning 6000 rpm plus.

60 degree V6 2.8, 3.1, 3.4 -- there are versions of the 2.8 with and without the crank reluctor ring (timing wheel).  This modification is also available for the other strokes.  $94.95

 

 

The pictures below show the scraper for the 3.4 with aluminum sump and cross-bolted mains.  The scraper is designed to fit under the factory windage tray as well.

 

 

 

 

Copyright 2002-2024 © All rights are reserved on our product designs -- a great deal of hard work goes into each one.

Teflon® is a registered trade mark of E.I. du Pont de Nemours and Company. Only DuPont makes Teflon® resin sourced by Ishihara-Johnson Crank Scrapers from authorized DuPont licensees.

We Ship World Wide!

Jean-Claude 1919-2003
A good friend.