(727) 808-8602
Home Latest New Products Customers' Rides Orders, Terms and Conditions
What a crank-scraper is and other technical info... Some comments on our products...
 
Alfa-Romeo,AMC,BMC,BMW,Buick,Buick-Rover,Cadillac,Chevrolet,Chrysler/Mopar,Datsun-Nissan,Fiat-Lancia,Ford,GM,Honda/Acura,IHC,Jaguar,Lotus,Mazda,Mercedes,MGA/MGB,Mitsubishi,Oldsmobile,Opel,Pontiac,Porsche,Renault,Studebaker,Suzuki-Geo,Toyota,Triumph,VW,Volvo

We will try to keep this list updated but if you do not see your engine listed here please ask!  We can  do custom stroker or knife-edge crank designs.  We can provide templates for initial fitting and adjustment. Templates cost $100 and are a separate charge from the scraper pattern chosen.

We have included some representative pictures of the scrapers we make.  If you would like to see a picture of a particular scraper please ask -- we would be more than happy to send one through.

When available (please enquire) our zero-clearance Teflon® scrapers run an additional $130.00 to the cost of the standard steel scraper unless noted.

Remember, your vehicle may have an engine made by a different manufacturer so check both product lines.  If you are still unsure, please contact us.

crankscraper, crank-scraper, crank-scrapper, crank, crankshaft, rod-bearing, main-bearing, connecting-rod, counterweight, piston, windage, windage-tray, windage-cloud, oil pan, oil-pan, oil-aeration, oil-foaming, oil-cloud, racing, drag racing, road racing, drag-race, road-race, road-course, drift, drifting, time-trial, performance, power, horsepower, HP, torque, TQ, friction, vacuum, economy, engine, motor

 

Chevrolet

 

Copyright 2002-2024 © All rights are reserved on our product designs.

Big Block 366, 396, 402, 427, 454, 502   $94.95; Teflon® version available

The standard scraper is designed to work with factory fasteners (bolts).  Customers have asked for a version that will allow the use of ARP studs on the outer bolts of factory four-main caps.  The stud passes through the plane defined by the scraper and so relief holes are required.  At the ends of the scraper this requires reinforcement.  (The standard scraper design will work with splayed 4-bolt caps and bolts.)  $154.95; Teflon-bladed versions are available (pictured below is a 396)

Copyright 2002-2024 © All rights are reserved on our product designs -- a great deal of hard work goes into each one.

Teflon® is a registered trade mark of E.I. du Pont de Nemours and Company. Only DuPont makes Teflon® resin sourced by Ishihara-Johnson Crank Scrapers from authorized DuPont licensees.

We Ship World Wide!

Jean-Claude 1919-2003
A good friend.